@IM1RU
I think you mistook the point of this thread. I KNOW I have the potential to bind something. I'm wondering what people are doing to PREVENT the binding if they have SPC arms. Are they using limiter straps? Are they just wheeling carefully? do they just tear through their CVs/ball joint...
@TerryD I'm wondering if we are talking around each other? You mentioned you have your Radflos set to 2.5" preload lift with a 0.5" spacer which should provide 3" of lift.
I was planning to set my preload lift to 0.5" with a spacer of 2.5". From my reading, isn't this an optimal setup...
Th
Right, that was my understanding. I was wondering if anyone has tried to mitigate that by using straps? Or Maybe it would just be easier to get some bumpstops welded to the UCA...
Hey all, this is probably a dumb question, but one I haven't seen answered or even discussed anywhere on this site or others. I'm likely just bad at googling.
I have a 2013 S with SW bumper with winch, engine and rad skids, sliders, and rear bumper. I recently purchased the AllDogsOffroad 5100...
No, the melt mod bends the plastic above this point. This point is actually a bit that covers the welded joint of the skin. You can see it running back towards the rear.
At least....I thought so? Am I wrong?
Hey All,
So I just got back from the tire shop with these great Yokohama Geolander 285s.
Unfortunately, this little nubbin in the back front fender rubs on both sides (one more than the other).
Any thoughts on how to fix this little issue? I'm assuming it will involve some trimming? Is the...
Yup, Zack got it. I will say that also there has been some discussion about whether the alternator functions appropriately with our machines. I forget the specifics now, but there was discussion on TheNewX where users were having to alter it manually.
Title says it. Looking to buy, I'm in NorCal willing to travel within reason to meet. I have a stock bumper I'm willing to trade.
Looking for Rad Skid and Bumper with Hoops, will take the winch too if offered. Looking to spend around $1500 for Bumper, Skid, and winch in decent condition.
Hey All,
Just got back from a trip doing the old Mojave Road. For those of you familiar, against my better judgement, I bent to peer pressure and completed the Afton Crossing. After the Afton crossing and before the train trestle is another developing hole...and here the bottom is soft; I got...
These are the stakes I bought to anchor the legs, I'm going to use hose clamps to attach them for now. Eventually ill use pins and drill holes in the legs.
Nice CHUG! I'm planning on using a bungie wrapped under the middle foot of the roof rack from one grommet to the other to keep the center down. On the other hand, the outside edge is completely screwed down to the front bar, so it can't flop any where. Im thinking that due to the size, this will...