Search results

That actually wasn't all that hard...installing headers without bodylift. Now that's a Sundae!

Right on, thanks. Lol I would write it up but others do far better.

Would the SD33 be an engine swap possibility? On first gen

I will have to check into that. Thank you, anyone have a P/N off hand?

I'm trying to track down a misfire in cyl. 2. I had it (p0302) awhile back. Did the plugs, wires, cap n rotor. Went away. It's back lol. When you say "build your own" what does that take? Just the bearing? Thanks

Hey XN!! ANY advice on which distributor to buy? 00 X 3.3l Thanks

This is the skill I lack, troubleshooting. Haha. I'll look at that #2 cyl. Inj. Wiring for damage.

I removed air intake up to the throttle body, disconnected pipes to primary cats. Then worked up from there removing cats and stock manifold. I'm thinking it's fuel related. I have spark. I checked for air leaks around air lines. Hmmmmm

Haha, i got that code p0300, it's gone. Now I have a p0302. I'm not finding the reason for this. I still have some stiff I can check but it wasn't missing before the headers were installed.

Thanks for the help guy's. Good lookin out. Peace

I fixed the p1168 now I'm getting a p0300. What is going on now? Where do I start

I drove it home, no leaks from headers or collector flange. I got a code p0302 and p1168. I assume the p0302 is related to the other code. I didn't have the p0302 code before the install. I should be receiving the angled CEL (2ea.) Today or tomorrow. I reused the driver side upstream o2. Could I...

Any other Oregonians on here?

Awesome, big help. I did the work at a buddies house. Can I screw in that downstream sensors to drive it home. 10-12 miles

I forgot, can I just buy a downstream (the smaller O2) 02 sensor and install in its place?

Hey guys, just finished installing Doug Thorley THY-465-L-C headers, now to my O2 Sensors. My upstream passenger side 02 is bigger then the bung in header. I noticed the upstream O2 Sensors are bigger then the downstream 02 sensors. What can I do? Thanks guys

Hey prime, I got the headers installed. My O2 sensors up stream does not fit the bung hole of the O2, they are a little larger on passenger side. Then my O2 sen upstream on driver side has no bung for it. The EGR plug is in front on top of header then the downstream O2 sensor. I guess my...

Thanks for your patience with my lack of knowledge on the subject. I will hopefully be doing it this weekend. Whenever I do i will take pics

Ah ha lol. Makes sense Ok, either way I need 2 extensions, roughly 7" from front pupe, to y pipe

Awesome thanks