Cptpackrat
Bumpers Installed
- Location
- Gillette WY
The diff is looking good
Thanks. Im hoping to close up a few things tonight and get the rest of the steering parts ready to go together so I can just roll the axle under next friday
The diff is looking good
Dude. Wrong forum.I'll take some pictures of my junk
Dude. Wrong forum.
I'm gonna go w/ no....we are not enough.Y’all are to much... lol
I'll take some pictures of my junk with a drilled stock arm with it's relation to the Calmini bracket when I get a chance. My turn radius is limited by the throw of the stock pitman arm/steering box; I don't hit the steering stops on ether right or left turn when the steering is centered...
i come back for once and see this clean ass pitman arm.
dont forget to file the one tooth for the key
...I disagree. I might get banned but here it is, my junk;Dude. Wrong forum.
...I disagree. I might get banned but here it is, my junk;
Great job. Feels nice to get it on its own weight again i bet.
Is the steering issue because of the tie rod flip. Are going to move the axle or frame side of the track bar, or try changing pitman arms.
Sooo what I have been told since I used an above the knuckle TRE the drag link bolts in from the front. This causes it to cross over the tie rod and cause contact. The remedy is to use and under the knuckle TRE which will cause the drag link to bolt in from the rear and no longer cross the tie rod. I ordered one and should have it hopefully this week. Im gonna try to drive the truck very little until I get this done as I reeeaaally dont want to cause any worn or broken parts