Who wants to pay 200 or more for a body lift? If you want to run 33" tires and not cut your Xterra up your going to need a 2" BL
You can piece together a Bodlylift (BL) for 70.00$ range.
You will need 10 - 2" tall 3" wide lift blocks.
Zoneoffroad.com (ZON3296) or Ebay is the best place I have found on these..
Range 2.75 to 3.00 So your looking at 30.00 Plus shipping right there.
Next you need the bolts to add to the kit.
Since all the bolts holding your Xterra on the frame right now will be useless your going to need new Grade 8 bolts
Allensfasteners.com is one of the best places I have seen for these..(Those #s at the front are the parts numbers from Allen) You may look local 1st vut most Big Box stores do not carry some of the sizes.
70329 10mm-1.25 10.9 HEX BOLT 2 $3.95 $7.90
LENGTH: 10mm-1.25 X 160 10.9 HEX CS
-------------------------------------------------------
70303 10mm-1.25 HEX BOLT 8.8 2 $1.24 $2.48
LENGTH: 10mm-1.25 X 80 8.8 HEX CS (part thread) plain
-------------------------------------------------------
70333 12mm-1.25 10.9 HEX BOLT 2 $5.75 $11.50
LENGTH: 12mm-1.25 X 180 10.9 HEX CS
-------------------------------------------------------
0027 7/16-14 GRADE 8 HEX BOLT 6 $1.00 $6.00
LENGTH: 7/16-14 X 6 GR8 HEX CS
-------------------------------------------------------
20287 AMERICAN GRADE 8 SAE FLAT WASHER 12 $0.11 $1.32
SIZE: 7/16 GR8 SAE FW (.925 O.D.)
-------------------------------------------------------
00006 GRADE C LOCK NUT (STOVER) 6 $0.17 $1.02
SIZE: 7/16-14 GRC NUT (STOVER) (11/16 hex size)
-------------------------------------------------------
First number in each bolt listing should be a part number on allensfasteners.com
thats 30.22 (Prices 5/11)
*Some people will use Grade 10.9 on every bolt*.. Up to you
4 nylon/rubber washers for those who want to keep their driveshaft safety loop
Now you will still need to raise the front bumper 2"
Many people will buy a 2x2 box metal and drill it to match the holes from the bumper.
UPDATE
Here is the numbers for a 1" BL as done by a member here.
I just installed my 1" BL today. Below is my hardware list and everything was the right size:
Hardware used:
(2) 10mm-1.25 x 55 8.8 HEX CS
(2) 10mm-1.25 x 140 10.9 HEX CS
(2) 12mm-1.25 x 14010.9 HEX CS
(6) 7/16 -14 x 5 GR8 HEX CS
(6) 7/16-14 GRC NUT
(16) 7/16 GR8 SAE FW (.925 OD) flat washer |