The Greater Post Whore Society - Volume 2: Welcome Home

Status
Not open for further replies.

OffRdX

Lockers Installed
Location
Port Orchard, WA
I don't understand how that's cheaper to run a whole separate compressor, wiring, lines, etc. I would really like to see your work.
i changed my mind again lol. I wasn't reading the fine print. I didn't realize the solenoid would thread straight into the manifold. So ya, I re-ordered the manifold and I am going to return the compressor. Plus I was able to find push lock air fittings way cheaper on Amazon vs. Fastenal/Grainger and in smaller quantity. So I got a T fitting to tap in downstream of my regulator that will send air to my manifold via a push lock 1/4 OD - 1/4 NPT male adapter.

I was looking at the wire harness for the ARB. I guess it's "cool" that they include everything but all I could think while staring at it was that I didn't want to use it haha. It wouldn't have worked for the setup I wanted. I should consider their target audience and just shut up.
 

Prime

Shut up Baby, I know it!
Admin
Location
Denver Adjacent
i changed my mind again lol. I wasn't reading the fine print. I didn't realize the solenoid would thread straight into the manifold. So ya, I re-ordered the manifold and I am going to return the compressor. Plus I was able to find push lock air fittings way cheaper on Amazon vs. Fastenal/Grainger and in smaller quantity. So I got a T fitting to tap in downstream of my regulator that will send air to my manifold via a push lock 1/4 OD - 1/4 NPT male adapter.

I was looking at the wire harness for the ARB. I guess it's "cool" that they include everything but all I could think while staring at it was that I didn't want to use it haha. It wouldn't have worked for the setup I wanted. I should consider their target audience and just shut up.
Good. Because I was confused.
 

JeffPro4x

Hot Pipe
Super Moderator
Supporting Member
Location
Glenside, PA
I mean, there is a ton of trolling in the Facebook groups. That's usually done by established people that know what they're talking about though
 

harryron

The Grumpiest of Mid-Westerners
Location
ohio
I know, you’d think it would at least be a little bit better with people learning a trade
The problem with going into trade work is that it is getting harder and harder for people to earn a living. If it was not for my wife's income we would be living in poverty.
 
Status
Not open for further replies.
Top