mantree
Wheeling
- Location
- Fort Collins
What did you use for your hinge on the swing out? I'm trying to get my swingout done before I'm homeless for a few days over the summer
Thanks man. Good to see you again.I keep going thru this build and keep wanting a 2nd gen.
I keep looking at how well this is done.
Awesome Job so far Jay!
:: shrug ::What did you use for your hinge on the swing out? I'm trying to get my swingout done before I'm homeless for a few days over the summer
Take a look here. This is what I will be upgrading toWhat did you use for your hinge on the swing out? I'm trying to get my swingout done before I'm homeless for a few days over the summer
Also sent u my address hope u got it. Thank uWhere is my coolant going?
Got a spike on the temp gauge last week. Cracked the radiator and couldn't see any coolant. Radiator took about half a gallon of coolant, and overflow too the same in water. Decided to check it again today and the radiator was low almost a half gallon again. WTF?
Oil is clean, no white smoke, once the coolant starts circulating it crystal clear green. No foreign colors or debris. Can't see any leaks. It's ufcking bizare.
Where is my coolant going?
Got a spike on the temp gauge last week. Cracked the radiator and couldn't see any coolant. Radiator took about half a gallon of coolant, and overflow too the same in water. Decided to check it again today and the radiator was low almost a half gallon again. WTF?
Oil is clean, no white smoke, once the coolant starts circulating it crystal clear green. No foreign colors or debris. Can't see any leaks. It's ufcking bizare.
Funny though. I took the rear corners off the weekend after I bought the truck. Knowing this was the plan. I guess I was just waiting for @maillet282 to find flush mounts with built in turn signals. Because in reality, this is a really easy job.
That said, I'll have a set of flush mounts to sell here in a minute. Since I bought them new like two years ago.
What are you using to create a water proof seal for you wires?
A cable gland. I bought a variety pack from Amazon when I did my roof wiring.What are you using to create a water proof seal for you wires?
Cool thanks. Will look on amazonA cable gland. I bought a variety pack from Amazon when I did my roof wiring.
After you drill a hole, there is a nut on the back side that pulls the gland tight to the metal, then you wrap the wires in electrical tape so it makes a single cable. From there you slide it through the gland and tighten the outer nut. That crushes a rubber gromit on the wires and creates a water tight seal.
Man Colorado has much better looking plates than ohio.
Man Colorado has much better looking plates than ohio.
That’s probably the source of your wheel speed sensor issueWell shiat. My front driver's side hub sounds like a box of rocks.
Probably. I noticed the sensor tripped more as the noise got worse.That’s probably the source of your wheel speed sensor issue